Technicolor MediaAccess TG799vn - Adding Rules for Address-Based Filtering

101
10 INTERNET SECURITY
DMS-CTC-20110713-0016 v2.0
10.1.2 Adding Rules for Address-Based Filtering
Introduction
Address-based filtering has a higher priority than content-based filtering. This means that when you are blocking a specific
category, you can still access a specific site if you allow it in the address-based filter.
Example
If you block content from the Finance / Investment category and allow access to netbanking.mybank.com,
netbanking.mybank.com will still be accessible.
Options
With the address-based filter you can:
 Deny access to a specific web site.
 Allow access to a specific web site.
 Redirect a web site.
 Redirect all web sites.
Deny access to a specific web site
Proceed as follows:
1 Browse to the MediaAccess Gateway GUI.
For more information, see “Accessing the MediaAccess Gateway GUI” on page 37.
2 On the Toolbox menu, click Parental Control.
3 Make sure the Use Address-Based Filter check box is selected.
4 Type the URL of the Web site you want to block (for example “mail.provider.com”) in the Web Site box.
5 In the Action list, click Block.
6 Click Add.
Allow access to a specific web site
Proceed as follows:
1 Browse to the MediaAccess Gateway GUI.
For more information, see “Accessing the MediaAccess Gateway GUI” on page 37.
2 On the Toolbox menu, click Parental Control.
3 Make sure the Use Address-Based Filter check box is selected.
4 Type the URL of the Web site you want to allow (for example “netbanking.bank.com”) in the Web Site box.
5 In the Action list, click Allow.
6 Click Add.
Redirect a web site
Proceed as follows:
1 Browse to the MediaAccess Gateway GUI.
For more information, see “Accessing the MediaAccess Gateway GUI” on page 37.
2 On the Toolbox menu, click Parental Control.
3 Make sure the Use Address-Based Filter check box is selected.
4 Type the URL of the Web site you want to redirect (for example “cracks.am”) in the Web Site box.