26
3 MANUAL INSTAL
LATION
DMS-CTC-20110713-0016 v2.0
3.1.2 Setting up your MediaAccess Gateway as Local
Router
Procedure
Proceed as follows:
1 Take an Ethernet cable. If your box contains an Ethernet cable with red connectors, you can use that cable.
2 Plug one end of the cable in the red WAN port on the back of your MediaAccess Gateway.
3 Plug the other end of the cable into the Ethernet port of your Internet gateway/modem.
The WAN port can only be used to connect your MediaAccess Gateway to an Internet gateway/modem. You can
not use it to connect other devices (for example, a computer) to the MediaAccess Gateway.
To Next Page
Loading...
