Technics QUARTZ ST-Z400L User Manual

ys wey 4- Tole) &
Stations can be freely preset to any desired channel.
Power: “on” ( 2+» )
¥} Press the “FM”, “MW” or “LW” button.
Press the appropriate tuning button to
tune to the desired broadcast.
e Auto tuning @ Manual tuning
Press the button. When the Press the button momentarily
frequency indication begins and tune to the desired station
to change, release the (the frequency will change each
button (a broadcasting time the button is pressed).
station will be selected
automatically). Repeat this
operation until the desired
station is found.
Memory indicator
(4) Press momentarily, and then release.
(The memory indicator will illuminate for
approximately 4 seconds.) (5) While the memory indicator is
illuminated, press the button of the
bd desired channel.
Ci When the button is pressed, the memory
indicator illumination will stop, and the
presetting is complete.
Note: Note:
If the button is pressed continuously, the 1. If the memory indication illumination
frequency will begin to change, and the stops before you press the button, once
memory
will
be
preset
automatically.
again
repeat
step
(4)
and
then
step
(5).
To
stop
the
automatic
memory
presetting,
2.
If
a
new
broadcasting
station
is
preset
once
again
press
either
the
“up”
button
or
into
a
channel,
the
broadcasting
station
the
“down”
button
which
was
previously
entered
in
that
channel will be automatically erased.
enter the name (call sign, etc.) of the preset broad-
casting station on the station memory file sheet.
This completes the procedures for presetting radio broad-
cast frequencies. The other preset-tuning buttons can be
preset in the same way by following steps (2) through (5).

Technics QUARTZ ST-Z400L Specifications

General

Brand	Technics
Model	QUARTZ ST-Z400L
Category	Tuner
Language	English