Technics RS-BR465

HSIT9N3
Front
Panel
Controls
and
Functions
(continued)
24) 28)
uaa =play </>
oa Fall seat rel walle
moo
c
=a
Co{I/Croz
I/Normal
N/Metal;
M.stop
MPX(B)
(oF
64)
80)
Display Section
@
@
©
Recording indicator (—R%)
Iluminates to indicate that this unit is in the recording stand-by
or recording mode.
Playback indicator (play)
When this indicator illuminates steadily, it indicates that this
unit is in the playback or recording mode. When it flashes
continually, it indicates that this unit is in the pause mode or
the recording stand-by mode.
Reverse-side indicator (<)
IIluminates to indicate that side “B” of the tape is being used.
Forward-side indicator (>)
Illuminates to indicate that side “A” of the tape is being used.
Input level meter
During playback, this meter indicates the level of the recorded
sound.
During recording, it indicates the level being recorded,
adjusted by the recording-level control.
Dolby noise-reduction indicators ([B], [Cc]
One of these indicators illuminates to show the type of Dolby
noise-reduction system selected.
@)
Multiplex filter indicator (MPX)
Illuminates to indicate that the multiplex filter is set to “on”.
(See page 14.)
Memory-stop indicator (M.stop)
This indicator illuminates to indicate that this tape deck is in
the memory stop mode.
Tape-select indicators
The type of tape being used will be automatically detected.
The corresponding indicator illuminates to show the tape type.
Reverse-mode indicators (——, C.>)
One of these indicators illuminates to show which type of the
reverse mode was selected.
Tape counter
Indicates the amount of tape movement.