Technics RS-D200

Ba
“
a
o}
Zz
Ww
Before requesting service for this unit, check this table to deter- mended that you consult the store where this unit was purchased
mine if the problem can be solved as described below. If the or your local Service Center (see list included) for further infor-
problem still persists after making these checks, or if there are mation and assistance.
symptoms of malfunction not described in this table, it is recom-
oe Problem ees Pomees ow Probable cause se ape oon ose Suggested remedy
Tape moves but no sound is Tt e volume contro! of the stereo amplifier is set to Adjust th u j
Jas I r
it
ini
it
‘
I]
e
volume
control
to
the
desi
ed
level.
The input selector of the stereo amplifier is not set | Set to the “tape” position.
to the ‘‘tape” position.
Distorted sound The recording level is too high. Referring to the section ‘“‘Adjustment of the record-
ing level” on page 7, make recordings at the most
suitable recording level.
Strange tone quality or rag-| The noise-reduction switch is not set to the correct | Set the switch to the position corresponding to the
ged sound position. setting used for recording.
No recording when the re-| The accidental-erase-prevention tab(s) of the cas- {| Cover the tab hole(s) with cellophane tape.
cord button is pressed. sette have been broken out.
Playback sound is unclear or} The heads are dirty. Clean the heads as described in the section
wavering; clear recordings “HEAD CARE” on page 8.
can’t be made. There is foreign material on the pinch rollers or,
capstans.