The radio
22
RQT5861
You can tune radio stations manually by selecting the station’s
frequency, or you can preset up to 30 stations into channels to
make tuning simpler (
\
page 23).
1 Turn [INPUT SELECTOR] to select
“
TUNER”.
2 Press [BAND] to select
“
FM” or
“
AM”.
3 Press [TUNING, 2, 1, PTY
SELECTOR] to select the frequency of
the station.
“
TUNED” lights when tuned.
“
STEREO” lights during FM stereo broadcasts.
Automatic tuning
Hold down [TUNING, 2, 1, PTY SELECTOR] until the frequency
begins to scroll. Tuning stops when a station is found. (Tuning may
stop if there is interference.)
Improving reception
¡FM mode
You can improve FM reception by switching reception to
monaural.
Press [FM MODE, EON].
“
MONO” lights.
Press [FM MODE, EON] again to cancel.
¡VGCA
You can improve reception by turning the VGCA on
(a page 20).
¡For your reference
DVD players can interfere with radio reception. Turn the DVD
player off or move it further away from the antennas if this occurs.
To change the AM frequency step
Press and hold [BAND] for about 3 seconds when AM band is
selected. (The frequency step changes from 9 kHz to 10 kHz.)
To return to the previous step, press and hold [BAND] for about
3 seconds again.
Manual tuning
qq
Press [TUNER/BAND RECEIVER].
The band changes each time you press the button.
ww
Press [DIRECT TUNING/DISC].
ee
Press the numbered buttons to enter the
frequency.
e.g. To select 107.90 MHz, press [1] / [0] / [7] / [9] / [0]
1. If you do not press a button while the cursor is flashing, the
display returns to the frequency being received.
2. If the frequency has not been input correctly, “ERROR” will be
displayed.
Note
To Next Page
Loading...
Need help?
General
