Technics SA-DX850

Customizing your receiver
14
RQT5818
For front speakers with an impedance under 6 Ω
SA-DX850
Turn “LOW IMP“ on if even one of your speakers has an impedance
under 6 Ω.
Press and hold [A] or [B] until “LOW IMP”
lights up on the display.
Press and hold down again to cancel “LOW IMP”.
Note that when “LOW IMP” is on, SPEAKERS A and B cannot be
used at the same time.
SPEAKERS A, B
SPEAKERS
AB
LOW IMP
SPEAKERS
A
D-INPUT
11
Press [B] (SA-DX850) or [SFC MODE] (SA-DX750) to select
the input position you want to set.
Each time you press the button:
CD COAX / DVD OPT2 / TV OPT1
↑
These are the factory settings. Actual displays depend on the
changes you make. If you change one setting, the other
corresponding setting will also change.
22
Turn [INPUT SELECTOR] to change the setting.
When you turn the selector:
COAX ,/ OPT1 ,/ OPT2
↑↑
33
Repeat
11
and
22
to change other D-INPUT settings.
DIMMER
Turn [INPUT SELECTOR] to change the setting.
When you turn the selector:
OFF ,/ ON