Technics SA-EX510

Operation e
| 00000
TEST
TEST -
Test signal
SECRETE HSEOSSHSHAEHARAEREREESRESH ESR ESSE ESE TSHTTSe EES betty eeereseresseses
— VOLUME +
CJC
8
SRAM RAOHR ESR ASCE TOH FUSES EEL OH TOD PSCC SOO H STE REC SRE S RARE O RAO RR EOoH AOE ORS
E t3aB
Output level
SA-EX410/EX310
CH SELECT — CHLEVEL +
my
=
| Enjoying sound with DOLBY PRO LOGIC |
Press TEST to output a test signal.
The speaker outputting the test signal is displayed while the
test is running.
L : Front speaker (left)
C : Center speaker
R : Front speaker (right)
S : Surround speakers
For surround mode
L—C—-R—S
= |
For 3 STEREO mode
L—C—R
| aeons
. Press VOLUME (-) or (+) to set the volume level
normally used for enjoying the source.
The following steps are for setting the output level of the
front speakers and the center/surround speakers to the same
listening level.
5 esa
Press CENTER ({-) or (+) or SURROUND (-) or (+)
to adjust the output level.
For SA-EX410/EX310
Press CH SELECT to select the center or surround
speakers, and press CH LEVEL (-) or (+) to adjust
the output level.
—: Decrease the output level.
+: Increase the output level.
Output level can be varied within a range of -12 dB to +12 dB
with front speaker output level serving as the zero point.
1. The test signal is output only by the speaker you are now
adjusting and does not repeat the sequence until
adjustments are complete.
2. Remember you cannot adjust output level of the surround
speakers if you selected the 3 stereo mode in step 1.
To stop the test signal
Press TEST.
For SA-EX510/EX410
Press OFF/ON.
For SA-EX310
Press the button of the currently selected mode (SURROUND or 3
STEREO). '