Technics SA-EX700

Enjoying sound with DOLBY PRO LOGIC
(Only available from the remote control.)
In order to reproduce the movement of the sound and its clear ori¬
entation, it is important to adjust the output level of each speaker.
Adjust output to the correct levels while listening to the test signal.
mm
® When ready to adjust speaker output level, situate yourself away
from the speakers as you normally do when listening.
« First turn ON the speakers with the SPEAKERS button on the
receiver.
» If front speakers volume is unbalanced, adjust the balance with
the BALANCE knob.
displayed while the test is running.
L: Front speaker (left)
C: Center speaker
R: Front speaker (right)
S: Surround speakers
For surround mode
L -* C -* R -* S
t_I
In the PHANTOM mode, the center
speaker is OFF, so the test signal is not
output and “C" is not displayed.
For 3 STEREO mode
L _* C -* R
t_I
, Press VOLUME ( ■ ) or (+) to set
^he volume level normally
used for enjoying the source.
1
The following steps are for setting the output level of the front
speakers and the center/surround speakers to the same listening
level.
Press SURROUND or 3
STEREO to turn on the
desired mode.
For SURROUND mode
Displayed for approximately 1 second
only.
For 3 STEREO mode
[ij /~ t m 3 3TERE0
Displayed for approximately 1 second
only.
CH SELECT
Press CH SELECT to select
the speaker you want to
adjust.
For the center speaker
For the surround speakers
b
i l 1 7 7
U O JD
18