Technics SA-EX700

Sleep timer function
The sleep timer is an excellent little feature that lets you fall asleep
with the radio. You can set the timer to turn off after 30, 60 or 90
minutes.
mJBWBBI
The sleep timer turns off the receiver, but it does not turn off any
externally connected components.
About the HELP function
if you make a mistake in operation or if sound output stops due to
some operation which was performed, the HELP function displays
information which can be useful for indicating the method by which
this condition can be remedied.
if “ERROR” or scrolling characters (for instance, 'TAPE MONITOR
ON HOW) appears on the display during operation, carry out the
following operation.
-HELP
-RESET
Set to the desired broadcast.
(See pages 14-16.)
(While listening a source)
Press SLEEP and set how
long (minutes) you want the
source to continue playing.
'I c c o
<_ C '
\ I /
30 - 60 — 90 — OFF
t_I
The display returns to the way it was
before in about 5 seconds
“SLEEP" indicator will appear
play.
, and the
on the dis-
\ snneo SLE
/ C n H i~l i~i i n
( iii o a ‘ >—l «
EP
IKx
-HELP
-RESET
Press -HELP.
(Touch only.)
The method for remedying this situation will be
displayed.
For your reference
If the above button is pressed for .2 second or more until “RESET"
appears on the display, the operation settings for the unit will be ini¬
tialized to the settings made at the time of shipment.
However, any broadcasting stations which have been preset into
memory wilt not be erased at this time.
When the -HELP button is flashing
When you press the -HELP button, it will stop flashing and the mes¬
sage “HIGH TEMP-REDUCE VOLUME" will scroll across the dis¬
play. This is to notify you that the receiver is hot for some reason,
perhaps because volume is too high or the ambient you're using
the receiver in is too hot. In this situation, you have to cool down
the receiver so try turning down the volume or turning the unit OFF.
If that doesn’t work, try cooling down the ambient.
The message will reappear every time you press the -HELP button
until receiver temperature is sufficiently lowered.
To cancel the sleep timer
Press SLEEP until “OFF’ is displayed. The “SLEEP" indicator will
go out.
To check how much time is left (while the timer is
running)
Press SLEEP once.
wvmnm
Do not press SLEEP again before the remaining time indication
goes out. if you do so, the timer will return to the setting mode.
To change the setting time (while the timer is run¬
ning)
1. Press SLEEP.
2. Press SLEEP again while the remaining time is displayed and
then reset the timer (30,60 or 90 minutes).
24