Technics SC-CH700 - Page 37

To find the beginning of a program
(TPS: tape program sensor)
This function can also be performed from the remote control. Follow
the procedure described below.
(While playing the tape)
Press the fast-forward/rewind/tape program sen¬
sor button.
I . ♦ ^ITPSi I (rpsi»» 1
When the forward side (>) is being played:
I iTPsi.^ I .The tape will be played from the beginning of the next
program.
[ <<,TPsi I .The tape will be rewound to the beginning of the
present program, then the program will be played
again.
While a TPS operation is taking place, the playback indicator will
flash.
When the reverse side is being played:
TJte reverse operation should be taken place.
Motes:
TPS function may sometimes fail to operate correctly In the
fptowing cases:
^hen the interval between program (the non-rocorded part) is
less than 4 seconds.
^hen a tape has been recorded with fade-ins and fade-outs.
tMVhon there is a particularly low level passage or silent passage in
the middle of a program.
sWhen a tape recorded from a microphone is being played back
(and there are no unrecorded blanks between the tape programs),
^hen less than 10 seconds remain until the start of the next
^program.
To fast forward or rewind the
tape
This function can also performed from the remote control. Follow
the procedure described below.
Press the fast-forward/rewind/tape program sen¬
sor button in the stop condition.
1 .^ITPS) I 1
The tape will start moving at high speed in the direction of the arrow
(. ^). regardless of which side is being played back.
Concerning the fade-in and fade-out
The volume level will
gradually increase (fade in)
Beginning of a program
The volume level will
gradually decrease (fade
out)
End of a program
37