Technics SC-CH700 User Manual

2
Link edit-recording
When recording of the first disc has finished and the link indicator
illuminates, the tracks of another disc can be recorded.
(After recording of the first disc has finished)
1 Press the disc tray open/close button to open
the disc tray and then replace the disc.
Tracks to be recorded on the tape left will be automatically
calculated and displayed.
Tracks that can be recorded on side B
'll, .li lL -JlBnl,.
..J
TMCK
4K mjorm
r •/"/ i 1
U ’LJ /
WM SSC
The link indicator will illuminate -
2 Press the play button to start recording.
After the recording level has been automatically adjusted, the
recording will start.
Notes:
•If there is not enough space at the end of the tape, it may not be
able to record on the tape left.
•In case you record more than third discs, follow the above proce¬
dures.
•After finishing the recording the first disc using the sequencial
editing or fade-in editing, tracks to be recorded on the tape will not
be displayed, but it is possible to record another disc.
•When the first disc has been edited using the Al function, you can
not make a link edit-recording from tape side A to B.
■ To cancel the link edit-recording
This function can also be performed from the remote control. Follow
the procedure described below.
Presa the stop button on the cassette deck.
ATLS (Automatic Tape Level Setting)
The unit automatically searches for the peak point of the entire disc
or the programmed tracks.
When the peak point is found, the peak signal will be sent for about
7 seconds, and the recording level will be set automatically at the
cassette deck. (During this interval, the peak sound will not be
output.)
51

Technics SC-CH700 Specifications

General

Brand	Technics
Model	SC-CH700
Category	Stereo System
Language	English