Technics SH-8017 Service Manual

m@ CONNECTIONS
™@ For connection to the amplifier of electronic components.
VCR1/EQ
~ACIN
Integrated
REC
PLAY
[11]
amplifier
OUT BACK |
| |) | | AC OUTLETS
OOOCOO O O |G]
{000000 O 0 |@
. AC power supply cord
Stereo connection (included)
cables (included)
Voltage selector:
Before using this unit,
be sure to set to
correct voltage.
This unit
AC OUTLET (SH-8017)
m——- TAPE———a
REC OUT PLAYBACK
VOLT ADJ
LINE IN LINE OUT
These terminals are connected to the
second audio tape deck.
‘“‘UNSWITCHED” outlet: Power is always
available, regardless of power switch
setting. Equipment rated up to 150 W can
be connected.
Notes:
@A receiver or preamplifier can be connected in the same manner as describes above. An integrated amplifier is used here for example.
@ Note that the way the input and output cords are routed (for example, if they are tangled with the power cord) could cause a hum to be emitted.
g DISASSEMBLY INSTRUCTIONS
How
to
remove
the
cabinet
ial
Procedure
Procedure
:
1-3-4
How to remove the power
supply P.C.B. and Jack P.C.B.
1. Remove the 4 screws (@~@) of power
supply P.C.B.
2. Remove the 3 screws (Q@~@) of Jack
@Remove the 5 screws (@~@).
oO
How to remove the switch
How to remove the connector
| Fet.Ne. | How to remove the connector P.C.B., and volume P.C.B.
Procedure 1. Remove the 2 screws (@, @).
1>3—5 2. Push the 10 tabs aside (Q~@®).
3. Remove the power switch button (@®) in
the direction of the arrow.
Procedure e Disconnect the lead ties of the 2
1—2 connectors (J1, J2).
flat cable
i. ae How to remove the front panel
@ How to fit the volume rod
Procedure 1. Remove the 2 screws (@~@). Front panel
1—3 2. Push the 3 tabs projected from the
bottom board in the direction of the
Volume shaft =
Light guide plate LED
>
Insert with long leg (anode) down.
Fit the knob with gate hole side down.
Front panel

Technics SH-8017 Specifications

General

Brand	Technics
Model	SH-8017
Category	Recording Equipment
Language	English