Connections
Refer to the operating instructions of the /
amplifier for further details. J
• Connect to the input/output (EXT OUT/EXT IN) terminals of an integrated amplifier.
Using the connection diagram below, corrected signals from any source can be heard or recorded onto the tape deck.
External output terminals (EXT OUT) I
External input terminals (EXT IN) I
)(R)(L)(R)(L)
Integrated
amplifier (option)
If the amplifier does not have external input/output terminals (EXT
OUT/EXT IN).
• Connect to the -rAPE monitor terminals of an integrated
amplifier.
To the AC outlet of the audio equipment, or household AC outlet.
( Refer to the operating instructions of the amplifier. )
_AC power supply cord
(included)
This unit
(SH-8038)
(R)(L) (R)(L)
Stereo connection _._...___
cables (included)
(L)(R) (L)(R)
"UNSWI'rCHED" outlet: Power is always
available, regardless of power switch set-
ting. Equipment rated up to 150 W can be
connected.
Tape deck
(option)
Note: A receiver or preamplifier can be connected in the same
manner as described above. An integrated amplifier is
used here for example.
CAUTION:
TO PREVENT ELECTRIC SHOCK MATCH WIDE
BLADE OF PLUG TO WIDE SLOT, FULLY IN-
SERT.
Note that the way the input and output cords are routed
(for example, if they are tangled with the power cord)
could cause a hum to be emitted.
To Next Page
Loading...
Need help?
Frequency and Sensitivity
