Technics SL-6 - Page 4

m DISASSEMBLY INSTRUCTIONS
e
1.
2.
AWN = 6
—_
NOORWN
[ay :
How
to
remove
the
turntable
platter
e@
How
to
remove
the
bottom
board
Open
the
upper
cabinet.
1.
Remove
the
turntable
platter.
Remove
the
turntable
mat
and
lift
the
turntable
pistien,
2.
Remove
the
4
screws.
(Fig.
2:@~
@)
(Fig.
1)
Note:
F
2)
(1) When removing the turntable platter, it is not
necessary to remove the 45 r.p.m. adaptor.
(2) The turntable platter is tight fitted onto the center
spindle. When removing the turntable platter, take
care not to give damage to the upper cabinet, arm
motor cover and tonearm cover.
Turntable
Turntable
platter
Fig. 1
How to remove the operation circuit P.C.B.
. Remove the bottom board.
.
Remove
the
7
setscrews
(Fig.
3:
@
~
@)
of
the
printed
circuit
board.
.
Separate
the
optical
sensor
sensitivity
selector
switch
and
speed
selector
switch
from
the
knobs.
(Fig.
3-A)
.
Remove
the
printed
circuit
board
in
the
direction
of
arrow
(@).
Note:
The
printed
circuit
board
is
grounded
to
the
chassis
by
screw
@.
When
checking
for
conduction
removing
the
screw
@.,
connect
the
ground
terminal
of
the
P.C.B.
to
the
chassis
(stator
frame).
Speed selector
switch (9)
Optical |
sensitivity
(A) selector switch S |
How to remove the switchs (S301 ~ $312) Fig. 3 :
(Program keys, repeat and cueing control switches)
. Remove the operation circuit P.C.B.
. To remove $301 ~ $305, cut off the 2 clasw (Fig. 4: @, ®) of the LED holder. (Fig. 4-A)
. Remove the LED from the holder, and raise the LED. (Fig. 5)
. Release the claw A) of the LED holder and remove the LED holder from the printed circuit board. (Fig. 4)
Unsolder to remove the switch terminals.
. To remove $306 ~ $310, cut off claws @ and @.
To remove $311 and $312, cut off claws @ and @.