Technics SL-BD22D Service Manual

LOCATION
OF
CONTROLS
45-rpm adaptor
Turntable mat
Strobe lines
pilot lamp
Pitch control
(PITCH ADJ)
This
unit's
strobe
illuminator
operates
at
the
AC
line
frequency
which
generally
has
a
0.2%
fluctuation.
This
fluctuation,
when
present,
may
make
the
strobe
pattern
appear
to
change.
However,
actual
platter
speed
does
not
change,
because
the
DC
motor
is
notaffected
by
AC
power
line
frequency.
Notes:
*Do not try to clean the dust cover
while a disc is playing, because
static electricity might cause the
tonearm to rise.
{cin
Tonearm
©The
unit
is
in
the
standby
condition
when the AC power supply cord is
Arm rest connected.
The primary circuit is always “live” as
long as the power cord is connected
Set
to”
2"
to
stop
to
an
electrical
outlet.
the play temporarily.
Set to“ Z" to resume
the play.
Stop switch (STOP)
Press to stop the play.
Strobe-illuminator/
(CUEING)
3 Cueing control
Setto“Z”,
2
Speed
selector
(SPEED)
Set to disc’s speed.
1 Place a disc on the turntable mat.
@ Fora 17-cm (7”) (large center hole) disc
Remove the
stylus protector.
(The
tape
on
side
of
cartridge
prevents
the
stylus
assembly
from
shaking
loose
during
shipment.)
Move to the desired position.
(The strobe-illuminator/pilot lamp will light and the
platter will start turning.)
Cartridge
(TaD) is the standard mark for the “P-mount” plug-in
connector system. Products carrying this mark are inter-
changeable and compatible with each other.
Setto"z”.
(Play will start.)
@ When play ends
1. The tonearm will automatically return to the arm rest (the
automatic
return
feature).
2.
Rotation
will
stop.
[ After use
Attach the stylus protector.
Protector

Technics SL-BD22D Specifications

General

Brand	Technics
Model	SL-BD22D
Category	Turntable
Language	English