11
English
(11)
01 [NWP ]/[CD ]: Standby/on button
• Press to switch the unit from on to standby
mode or vice versa. In standby mode, the
unit is still consuming a small amount of
power.
The input source also switches for each
(switches to the last selected input source
when [NWP
]).
02 [NWP]/[CD]: Select the device to be
operated
• The playing layer switches by pressing [CD]
while playing Hybrid Super Audio CD.
• Press and hold [CD] to switch to “Pure Disc
Playback” mode. ( 17)
03 [>INPUT<]: Switch the input source
04 [DIMMER]: Adjust the brightness of the
power indicator, display, etc.
*
2
• Press repeatedly to switch the brightness.
Remote control
05 [INFO]: View content information
*
1
06 [ ], [ ], [ ], [ ]/[OK]: Selection/OK
*
1
07 [RETURN]: Return to the previous
display
*
1
08 [DIRECT]: Turn on/off Direct mode
09 [RE-MASTER]: Turn on/off Re-master
• Press and hold [RE-MASTER] for approx.
2 seconds so that “MQA Decoding” is
displayed and the MQA decoding function
will be set to “On”. (Press and hold for
approx. 2 seconds again to set the function
to “Off”.)
10 [MENU]: Enter menu
*
1
11 [SETUP]: Enter setup menu
*
1
12 Adjust the volume
*
2
13 Mute the sound
*
2
14 Playback control buttons ( 17)
15 Numeric buttons, etc.
• To enter 2 digits or more
Example:
16: [
10] > [1] > [6]
124: [
10] > [ 10] > [1] > [2] > [4]
• [CLEAR]: Clear the entered value.
*
1: Press [NWP]/[CD] first to operate this unit.
(The remote control works only for the
devices supporting system control function
when pressing [AMP].)
*
2: Also works for the devices supporting system
control function.
■ Buttons that work for Technics devices
supporting system control function
The remote control of this unit also works for
Technics devices supporting system control
function (Stereo Integrated Amplifier, etc.). For
information on the operations of the devices,
please also refer to their operating instructions.
01
[
] Standby/on button for the Stereo
Integrated Amplifier
02
Select the device to be operated
03
Select the input source
04
Measure the output signal of the amplifier
w
hen speakers are connected, and correct
its output
To Next Page
Loading...
Need help?
General
