10
Control reference guide (Continued)
(10)
01 Analog audio output terminals (ANALOG
OUT)
• You can connect the pre-amplifier which
has the unbalanced input terminals, etc.
with analog audio cable (supplied) to
output the analog audio signals.
• You can connect the pre-amplifier which
has the balanced input terminals, etc. with
XLR cable (not supplied).
02 Wireless LAN antenna
( 14)
03 Optical digital output terminal (OPT)
You can connect the digital audio output
device with optical digital audio cable (not
supplied) to this unit and play back music.
04 Coaxial digital output terminal (COAX)
05 Optical digital input terminal (OPT)
You can connect the digital audio output
device with optical digital audio cable (not
supplied) and play back music.
• The digital audio input terminal of this unit
can only detect the following linear PCM
signals. For details, refer to the operating
instructions of the connected device.
- Sampling frequency:
32/44.1/48/88.2/96 kHz
- Number of quantisation bits:
16/24 bit
This unit (rear)
06 Coaxial digital input terminal (COAX)
You can connect the digital audio output
device with coaxial digital cable (not
supplied) to this unit and play back music.
• The digital audio input terminals of this unit
can only detect the following linear PCM
signals. For details, refer to the operating
instructions of the connected device.
- Sampling frequency:
32/44.1/48/88.2/96/176.4/192 kHz
- Number of quantisation bits:
16/24 bit
07 Product identification marking
• The model number is indicated.
08 LAN terminal
( 13)
09 USB-A terminal (USB Rear)
(DC 5 V
1 A)
You can connect a USB device to the unit
and play back music stored on the USB
device. ( 18)
10 System terminal (CONTROL)
11 AC IN terminal ( )
( 12)
To Next Page
Loading...
Need help?
General
