Technics SL-G700M2

17
English
Playback
(17)
Basic
Playing back CD/SACD
1 Press [NWP ]/[CD ] to turn this
unit on.
2 Press [ ] to open the disc tray and
insert a CD.
Place label up in the proper position in the
middle of the disc tray.
DO DO NOT
12 cm CD
DO
DO
NOT
DO DO NOT
8 cm CD
DO
DO
NOT
• Press [ ] again to close the disc tray.
3 Press [ ].
Note
• Be careful not to get your finger caught in the
disc tray when opening/closing it.
■ Repeat Playback
Press [NWP].
Press [ ].
“1
”:
Only plays the selected track.
“
”:
All tracks are repeated.
■ Random playback
Press [NWP].
Press [RND].
• Press again to cancel.
■ Program playback
Press [NWP].
Press [PGM] in the stop mode.
• “Program Mode” screen is displayed.
Press the numeric buttons to select tracks.
• Repeat this step to make further selections.
Press [ ] to start playback.
• Press [
] or [ ] in the stop mode to check the
programed order.
• Press [CLEAR] in the stop mode to clear the
last track.
• Press [PGM] in the stop mode to cancel the
program mode, and the program memory
will be stored.
• Press [
] in the stop mode and select “Yes”
to cancel the program mode. (The program
memory will be cleared.)
Note
• The program memory will be cleared in the
following conditions.
- When turning on/off this unit
- when replacing the CD
- when switching the layer
• The program mode is cancelled when the
random playback is set.
■ Playing back Hybrid Super Audio CDs
Hybrid Super Audio CD discs include a
conventional CD layer along with the Super
Audio CD layer. Although Super Audio CD layer
is preferentially played back, you can select the
CD layer or Super Audio CD layer for playback by
pressing [CD] while the playback stops.
Note
• The layer cannot be selected on the disc except
Hybrid Super Audio CD discs.
• “Super Audio CD” is displayed as an input
source while Super Audio CD is played back.
■ Compatible CD
• A disc with the CD Logo.
• This unit can play back discs that conform to
the CD-DA format.
• The unit may not be able to play some discs due
to the condition of the recording.
• Before playback, finalize the disc on the device
it was recorded on.
■ CDs that cannot be used
• CDs with irregular shapes, such as heart shapes
(Use of such CDs may cause malfunction.)
■ CDs that are not guaranteed to operate
with this unit
• Discs with illegally copied data and those that
do not conform to industry standards
• DualDiscs (Discs that record data such as music
and images on both sides)
■ Disc formats supported by this unit
Super Audio CD (SACD)
Support
(2-channel only)
Commercially available CDs
(CD-DA)
Support
CD-R/CD-RW (CD-DA) Support
■ This unit’s lens
Use the lens cleaner (not supplied) to clean the
unit’s lens.
■ Clean discs
DO
DO NOT
Wipe with a damp cloth and then wipe dry with
a dry cloth.