Technics SL-J110R - Operation; Automatic Play Procedure; Manual Play Procedure; Operational Notes and Features

Output lead wire
Fig. 1
. Unsolder the 5 arm leads from the output
P.C.B. (Fig. 1)
. Turn over the unit (top side up), and then
remove the dust cover and the tonearm cover.
. Remove the 2 screws shown in Fig. 2.
. Release the tonearm clamper and move the
tonearm toward the center.
. Lift the tonearm unit.
How to remove the cueing selector
.
Remove
the
spring.
——
:
index
plate
.
Pull
out
the
rod
from
the
cueing
unit.
.
Remove
the
index
plate.
.
Remove
the
2
screws.
.
Lift
the
cueing
unit.
*
The
liftarm
can
be
replaced
without
removing
the
cueing
unit
in
the
procedure
shown
in
Fig.
2.
. Remove the ground lead screw. (Fig. 1)
.
Unsolder
the
2
terminals
of
the
plunger.
(Fig.
1)
Foy
.
Turn
over
the
unit
(top
side
up).
é
a.
/flian
the
pin
.
Release
the
claw
and
lift
the
main
gear.
pines
ag
7
NN
Ine
groove.
.
Remove
the 3
screws.
Screw
Unsolder