Technics SL-J110R

Accessories
• Platter mat . 1
Remote-control cord.. 1
Turntable Assembly
1. Remove the packing spacers.
2. Attach the drive belt properly.
Before Use
Be sure to disconnect the mains cord before adjusting the voltage
selector.
Use a minus (-) screwdriver to set the voltage selector (on the rear
panel) to the voltage setting for the area in which the unit will be
used.
Connections
Note that this unit will be seriously damaged if this setting is not
made correctly. (There is no voltage selector for some countries;
the correct voltage is already set.)
AC power supply cord — . r
REMOTE/SYNCHRO REC
._JTR] To household AC outlet, or the AC outlet of the audio equipment
PHONO
Stereo connection cable
If the AC power supply QG)p|-
cord is connected to [ j
the household AC ; j
outlet, cut off and [[_
dispose of the plug. \p,,T7
(Refer to "For United ii
Kingdom” on page 2.) IJr
; ^Remote-control cord (included)
Remote control terminal
Synchro recording is possible if a Technics amplifier with "SYNCHRO-
REC” or “CONTROL” terminal is connected. Also remote control
operation is possible if the amplifier has the remote control functions.
(Refer to the operating instructions of the amplifier and tape deck.)
'SYNCHRO-REC” or “CONTROL”
TURNTABLE Q O
Amplifier
Note:
Configuration of AC
power supply cord
differs according to area.
- 3 -