Technics sl-mc410 User Manual

® Set the changer on a flat, level surface.
® Before connecting the changer to your audio system, make
sure that the power of the changer and all other system
components is turned off.
»(For areas except United Kingdom, Australia and N.Z.)
Make sure the voltage selector is set to the connect position.
Stereo connection cable
(For United Kingdom only)
BE SURE TO READ THE CAUTION FOR THE
AC MAINS LEAD ON PAGE 3 BEFORE THE
FOLLOWING CONNECTIONS.
Receiver or amplifier
CD or AUX terminal
EteQg) (
^I* 0J AC W ~
To household
AC outlet
I AC power supply cord (included)
Voltage selector
(For areas except United Kingdom,
Australia and N.Z.)
(For areas except United Kingdom, Australia and N.Z.)
CAUTION:
Use a minus (-) screwdriver to set the voltage selector to the
voltage setting for the area in which the unit will be used.
(If the power supply in your area is 115 V or 120 V, please set
the voltage selector as follows:
For 115 V: set to 110 V
For 120 V: set to 127 V)
Note that this unit will be seriously damaged if this setting is
not made correctly.
Approx. 6mm
(For areas except United Kingdom, Australia and N.Z.)
insertion of Connector:
Even when the connector is perfectly inserted, depending on the
type of inlet used, the front part of the connector may jut out as
shown in the drawing.
However there is no problem using the unit.
(For areas except United
Kingdom, Australia and N.Z.)
If the power plug will not fit
your socket, use the pow'er
plug adaptor (included).

Technics sl-mc410 Specifications

General

Brand	Technics
Model	sl-mc410
Category	CD Player
Language	English