Technics SL-P110 - Page 10

6. Place the main P.C.B. as shown in the
figure.
Cautions:
1. Be sure to connect the P.C.B. ground
terminal (line out terminal) and chassis
lead wire.
2. Connect the ground terminal of loading
base to the chassis.
Ground terminal of
line out terminal g
Lead wire
Ref.sNo. How to ove the disc clamper Ref.eNo. I:%wato remove the power supply
re -‘
Pn:c:d:
*Remove
the
setscrew.
Prc:c:d:
®
|
«Remove
in
the
numerical
order
shown.
(Shift the disc holder forward.)
Remove the
‘? 2 setscrews.
_____ P
] i
..... cm\
4 Remove the_Li '~ ‘ L Pull out the
rod. | 2 connector.
. | /%(’( * Caution for fitting
-
STCRES
By
"
Fit
the
P.C.B.
in
the
Ref.No. | How to remove the disc holder.. . groove of chassis.
7 (disc tray)
Procedure
1525557
1. Push the holder lever backward, (From
e Make the drive gear as shown below.
(Turn it completely to the right, then
turn it to the left by about 20° so
that drive gear teeth or projection
will not touch the rack of disc
holder.)
Drive gear
projection
Leaf switch
(S101)
*To remove the drive gear
Remove the screw @) of leaf switch
(S101), then remove the drive gear
setscrew ®.
underneath the loading base.)
2. Pull the disc holder and bend the 2
claws of disc holder stopper of loading
base toward the optical pickup.
3. Further pull out the disc holder to
Stoppers
remove it.
Optical pickup
Loading base
Holder lever
e Caution for fitting
When fitting the disc holder, make the drive gear
as shown on the left, and then insert the disc
holder along the guide of loading base.
After inserting the disc holder completely, turn
the drive gear to the right completely.