Technics SL-PD647 - Removal of the clamper assy (yoke, magnet and clamper); Removal of the traverse deck; Removal of the tray base guide (L); Removal of the tray base guide (R)

SL-PD647 |
Ref.No. —_
9
Procedure
1-8-9
Removal of the clamper ass’y (yoke,
magnet and clamper)
Removal of the traverse deck
Traverse deck
Ref.No.
10
Procedure
1-2-3-7
Yoke
Magnet
Claw with projection
1.
While
lifting
the
claw
with
a
screwdriver,
rotate
yoke
in
the
Pulley
gear
direction of arrow and remove the yoke and magnet.
2. Release the 3 claws of the clamper.
1. Rotate the pulley gear in the direction of arrow @ until the
traverse deck comes up.
2. Pull out the FPC board (CN301).
Tray base
guide (L)
* Be careful not
to scratch or bend
the FPC board.
3. Release the 2 claws.
e
Remove
the
2
screws(@,
@).
|
4.
Remove
the
traverse
deck
in
the
direction
of
arrow@).
Removal of the mechanism base
ass’y
(2)
Procedure
Mechanism
base
1-2-3-7
>8—-10-13
1. Remove the 1 flat cable(CN404).
2. Remove the 4 screws(@~@).
1. Remove the 2 screws( @, @).
{Bottom side)
2, Release the 1 claw. : Z