Technics SL-PD647 - Removal of the main P.C.B.; Removal of the worm base and sensor P.C.B.; Removal of the tray motor assy; Removal of the worm assy

Procedure
1-2-3—12
14
1. Remove the 3 screws(@~ @).
2. Lift the main P.C.B. off the retention post on the chassis
ass’y.
3. Remove the 2 flat cable(CN11, CN404).
4. Pull out the FPC board(CN301).
5. Remove the main P.C.B. in the direction of arrow.
Procedure
1-2-3-6
1. Remove the 1 screw(@).
2. Release the 2 claws and then remove the worm base in
the direction of arrow®@.
Removal of the tray motor ass’y
/Mark(+)
Tray motor
Unsolder the
terminals
Tray motor ass’y
e Unsolder the terminals of the tray motor ass’y.
Chassis ass’y
Retention post
Sensor P.C.B.
3. Remove the belt.
4. Release the 3 claws.
Removal of the worm ass’y —
Procedure
1-2-3-6
1. Raise the worm pulley in the direction of arrow@.
2. Remove the worm ass’y by pressing the claw in the
direction of arrow@.
| SL-PD647