Technics SL1200MK2 - Schematic Diagram

m SCHEMATIC DIAGRAM
(This schematic diagram may be modified at any
time with the development of new technology.)
i
Mooney
10.
: Start/stop switch.
: Pitch control reset switch in "off" position.
Stylus illuminator switch in “ӨМ” position.
: Power switch in "on" position.
Voltage selector in "220 — 240" position.
The voltage value, and waveforms are the reference voltage values of this unit
measured by OC electronic voltmeter (high-impedance) and oscilloscope on
the basis of chassis, Therefore, the voltage value and waveform may include
some error due to the internal impedance of the tester or the measuring set.
CI isthe voltage when turntable is in stop.
° ) is the voltage when turntable is in rotation. (at 33 rpm)
+8 voltage lines.
Important safety notice.
Components identified by A mark have special characteristics important for
safety. When replacing any of these components, use only manufactures
specified parts.
The part No. of diodes mentioned in the schematic diagram stand for produc-
tion part No. Regarding the part No. with © mark the production part No.
are different from the replacement part No, Therefore, when placing an order
for replacement part, please use the part No. in the replacement parts list
ponents in the shaded areas of the schematic.
—19—