Technics SU-810 - Audio Input and Speaker Output Connections; Tape Deck and DAT Connections; Speaker System Wiring

Connect a second tape deck or a graphic equalizer.
(R) (U (R) (L)
^ A Aft
Tape deck 2 (not included)
LINE IN LINE OUT I
(|il)(L)(F:^)(L)
i fi fifi
Connection to speaker systems
One pair of speaker systems can be connected to the "A”
terminals of this unit and one pair to the "B” terminals.
■ Load impedance
• When only the “A" or only the "B” terminals are used:4-16
ohms
• When both the “A” and the "B” terminals are used simul-
taneously:8-16 ohms
To connect main (A) and/or second (B)
speaker systems_
C “TAPE 1/DAT” terminais _
Connect a first tape deck or a digital audio tape deck (DAT).
Tape deck 1 (not included)
LINE IN LINE OUT I
mi)(PD{L)
Main (A) speaker systems
(not included)
(R) (L) (R) (L)
Aft ft ft
(+) (-) (-) (+)
Second (B) speaker systems
(not included)
To connect the AC power supply cord
(included)
Connect the AC power supply cord (included) after all other
cables and cords are connected.
Configuration of AC power supply cord differs according to area.
I To connect cords to terminais
AC power supply cord (included)
Household
AC outlet
-For United Kingdom—^
Household AC outlet
Fit a suitable plug to an AC
power supply cord.
0 Strip off the outer cover¬
ing, and twist the center
conductor.
CD Turn 5 or 6 times.
10 mm
(13/32”)
(D Insert the wire and tighten
screw completely.
Pull the wire to assure a
proper connection.
Note: Be sure to only connect positive (-I-) cords to
positive (+) terminals, and negative (-) cords to negative
(-) terminals.
Note:
To prevent damage to circuitry, never short-
circuit the plus ( + ) and minus (-) speaker
- 5 -