8
∫ Buttons that work for this unit
1 [AMP Í]: Standby/on switch
Press to switch the unit from on to standby mode or vice
versa. In standby mode, the unit is still consuming a small
amount of power.
≥ The remote control do not operate when the power switch
lever is in the lowered position.
2 [AMP]/[NWP]/[CD]: Select the device to be operated
3 [N INPUT O]: Select the input source (> 13)
4 [DIMMER]: Adjust the brightness of the light and the
indicators
Each press of this button switches the brightness.
5 [LAPC]: Measure the characteristics of the amplifier
and correct its output (> 13)
6 [r VOL s]: Adjust the volume
7 [MUTE]: Mute the sound
Input indicator blinks. Press [MUTE] again to cancel.
∫
Buttons that work for the ST-C700/SL-C700
The remote control of this unit also works for the ST-
C700/SL-C700.
For information on the operations of the ST-C700/SL-C700,
please also refer to their operating instructions.
1 Standby/on switch for the ST-C700
2 Standby/on switch for the
SL-C700
3 Select the device to be operated
4 Select the input source of the ST-C700
5 Adjust the display brightness
6 Display HOME menu
7 Change the displayed information
8 Selection/OK
9 Return to the previous display
: Enter menu
;
Turn on/off Direct mode
<
Turn on/off Re-master
= Basic playback control buttons
> Numeric buttons, etc.
Remote control
[AMP] LINE indicator lights up
[NWP] COAX1 indicator lights up
[CD] COAX2 indicator lights up
SU-C700-SQT0489_PP_mst.book 8 ページ ２０１５年１月７日 水曜日 午前１０時３２分
To Next Page
Loading...
Need help?
General
