Technics SU-G700M2 Owner's Manual

21
English
Using analog audio input device
Operations
(21)
Analog audio cable (not supplied)
CD recorder, etc.
You can connect the CD recorder, etc. with analog
audio cable (not supplied) to output analog audio
signals from this unit (LINE1/LINE2/PHONO).
Using analog audio cable
1 Disconnect the AC power supply cord.
2 Connect this unit and a CD recorder,
etc.
3 Connect the AC power supply cord to
this unit. ( 13)
4 Press [AMP
] to turn this unit on.
Note
• When a digital audio signal (COAX1/COAX2/
OPT1/OPT2/PC) is selected as input source of
this unit, analog audio signal (LINE1) is output.
• The choppy audio occurs in output audio signal
when switching the input source.
Do not input the audio signal from PRE
OUT/LINE OUT terminals to the analog
audio input terminals of this unit. Doing so
may cause malfunction.

Technics SU-G700M2 Specifications

General

Output Power (8 Ohms)	70 W + 70 W
Output Power (4 Ohms)	140 W + 140 W
Analog Outputs	1 x Line
USB-B Input	Yes
Coaxial Digital Input	1
Headphone Output	Yes
Input Sensitivity	200 mV
Input Impedance	47 kOhms
Load Impedance	4 Ω - 16 Ω
Digital Inputs	Coaxial, Optical, USB-B
Analog Inputs	2 x Line
Phono Input	Yes
DAC	Yes
Bluetooth	Yes
Dimensions (W x H x D)	430 x 148 x 428 mm