Technics SU-R1000 Operating Instructions

19
English
Operations
(19)
Using analogue audio input device
Do not input the audio signal from REC
OUT/PRE OUT terminals to the analogue
audio input terminals of this unit. Doing so
may cause malfunction.
Connecting a power amplifier,
subwoofer, etc.
You can connect the power amplifier, subwoofer,
etc. with analogue audio cable (not supplied) to
output the analogue audio signals.
AUDIOIN
Analogue audio cable
(not supplied)
Power amplifier,
Subwoofer, etc.
1 Disconnect the AC mains lead.
2 Connect this unit and a power
amplifier, subwoofer, etc.
3 Connect the AC mains lead to this unit.
( 12)
4 Press the unit on/off button to the
[
] position.
Note
• For details, refer to the operating instructions of
the connected device.
• The audio signal output from the power
amplifier, subwoofer, etc. connected to PRE
OUT terminals can be enable/disable. ( 21)
Connecting a recording equipment
When connecting a recording equipment to this
unit, use the analogue audio cable (not supplied)
and connect REC IN terminal with the audio
output terminals of the connected equipment,
connect REC OUT terminals with the audio input
terminals of the connected equipment.
• Press [REC IN] to switch the input source to
“REC IN”.
AUDIOOUT
Analogue audio cable
(not supplied)
Recording equipment
Recording input
termials
(REC IN, AUX IN)
1 Disconnect the AC mains lead.
2 Connect this unit and a recording
equipment.
3 Connect the AC mains lead to this unit.
( 12)
4 Press the unit on/off button to the
[
] position.
Note
• The choppy audio occurs in output audio signal
when switching the input source.
• The audio signal output from recording
equipment connected to REC OUT terminals
can be enable/disable. ( 21)

Technics SU-R1000 Specifications

General

Brand	Technics
Model	SU-R1000
Category	Amplifier
Language	English