Technics SU-V500 - Listening to Sound Guide; Initial Power On and Volume Setting; Selecting Speaker Systems and Sources; Tape Monitor Indicator Functionality

saNDB GON
‘aenaon
od
ag omen
(2)
(©)
©)S
Before
operation,
set
VOLUME
to
the
“MIN”
position.
° °
A B
SPEAKERS
O
8
Press
POWER
to
switch
on
the
power.
Press
A
andior
B
to
select
the
speaker
system(s)
to
be
used.
Aand
8
refer
to
the
speaker
terminals
at
the
rear
of
the
unit.
The
corresponding
indicator
above
will
illuminate
to
Indicate
which
speaker
system
is
selected.
A:
Sound
can
be
heard
from
the
speakers
connected
to the “A” terminais.
B:
Sound
can
be
heard
from
the
speakers
connected
to the “B” terminals.
A
and
B:
Sound
can
be
heard
simultaneously
from
the
speakers
connected
to
the
“A”
ter-
minais
and
the
“B”
terminals.
off:
No
sound
will
be
heard
from
the
speakers.
(Both indicators will turn off.)
When
tape
1
monitor
indicator
illuminates
Iluminates
This
indicates
that
the
tape
monitor
function
of
this unit is ON.
(=)
TAPE 1
MONITOR
2.
To
listen
to
sources
other
than
a
tape
(TAPE
1),
be
sure
to
turn
off
the
indicator
by
pressing
TAPE
1
MONITOR.
HrvE aRECTOR
TAPE 1 MONITOR
Ly
MN MAX
Press
to
select
the
desired
source.
The
corresponding
indicator
above
will
illuminate
to
indicate
which
button
is selected.
TAPE
4
MONITOR:
To
listen
to
tape
{TAPE
1).
The
tape
monitor
indicator
will
illuminate.
(See
below.)
TAPE
2/DCC:
To
listen
to
tape
(TAPE
2)
or
digital
compact
cassette
(DCC).
AUX:
To
listen
to
equipment
con-
nected
to
the
“AUX”
terminals.
CD:
To
listen
to
compact
discs.
TUNER:
To
listen
to
radio
broad:
casts.
PHONO:
To
listen
to
phono
discs.
Start
the
desired
source.
(Refer
to
the
appropriate
operating
in-
structions
for
details.)
Turn
VOLUME
to
adjust
the
volume
level.
After listening is finished
Be
sure
to
reduce
the
volume
level,
and
turn
the
unit
off
by
pressing POWER.