Technics SU-V570 - Connecting Speaker Systems; Connecting the AC Power Supply Cord

“TAPE 1” terminals
Connect a first tape deck.
Tape deck 1 (not included)
LINE IN LINE OUT
“TAPE 2/DAT” terminals
Connect a‘second tape deck or a digital audio tape deck (DAT).
Digital audio tape deck (DAT)
(not included)
ANALOG
(Py fh
Wy by
“POWER AMP DIRECT” terminals
Connect a compact disc player.
A superior level of tone quality can be obtained, because the
signal from these terminals are sent directly to the volume con-
trol and power amp section of this unit.
The sounds from a component connected to these terminals can-
not be recorded.
Compact disc player (not included)
LINE OUT
To connect the AC power supply cord
(included)
Connect the AC power supply cord (included) after all other
cables and cords are connected.
Household
AC outlet
Connection to speaker systems
One pair of speaker systems can be connected to the “A”
terminals of this unit and one pair to the ‘““B” terminals.
Wi Load impedance
¢ When only the “A” or only the “B” terminals are used:4-16
ohms
When both the “A” and the “B” terminals are used simul-
taneously:8-16 ohms
To connect main (A) and/or second (B)
speaker systems
Main (A) speaker systems
(not included)
(right)
(left)
WOO
Second (B) speaker systems
(not included)
(right) (left)
i To connect cords to terminals
@® Strip off the outer cover- ©
ing, andtwist the centre ——=>= 9
conductor. 10 mm Twist.
: (13/32’’)
@ Turn 5 or 6 times.
@ Insert the wire and tighten
screw completely.
Pull the wire to assure a
proper connection.
Note:
Be
sure
to
only
connect
positive
(+)
cords
to
positive
(+)
terminals,
and
negative
(—)
cords
to
negative
(—) terminals.
Note:
To prevent damage to circuitry, never short-
circuit the plus (+) and minus (—) speaker
terminals.