Changing the note position etc. of the
recorded data
You can change the note pitch and position etc. of recorded data.
Select the function
1. On the SEQ MENU display, use the SONG
SELECT ∧ and ∨ buttons to select the number
of the song. Then select RANGE EDIT.
• The display looks similar to the following.
2. On the RANGE EDIT display, select a function.
3. Perform the editing procedures. (See below.)
• During the editing procedure, if the indicator
for the TEMPO/PROGRAM is lit, you can use
the TEMPO/PROGRAM for the editing func-
tion.
NOTE CHANGE
Change of pitch of specified notes.
1. Use the TRACK ∧ and ∨ buttons to select the
track you wish to edit.
• You cannot select the track for the CONTROL,
RHYTHM or CHORD part.
• If ALL is selected, all tracks will be edited.
2. Use the FIRST MEASURE ∧ and ∨ buttons
to specify the start point (measure number) of
the note change.
3. Use the LAST MEASURE ∧ and ∨ buttons to
specify the end point (measure number) of the
note change.
4. Use the TARGET NOTE ∧ and ∨ buttons to
specify the pitch of the note you wish to
change.
• The number next to the note name is its note
number.
5. Use the CHANGE TO ∧ and ∨ buttons to
specify the pitch you wish to change to.
6. Press the OK button.
• The confirmation display appears. Press the
YES button to execute the function, or press
the NO button to cancel the function.
Sequencer
Part IV Sequencer
105
QQTG0671
To Next Page
Loading...
Need help?
General
