VELOCITY LAYER
Adjust these settings to regulate the tone output
relative to the velocity.
1. Use the PAGE buttons to view the 3/4 display.
• The display looks similar to the following.
2. Use the buttons to the left of the display to
select a tone (1st, 2nd, 3rd or 4th).
3. Use the L-FADE ∧ and ∨ buttons and the LOW
∧ and ∨ buttons to define the
sound output
area for the lower range.
4. Use the HIGH ∧ and ∨ buttons and the H-
FADE ∧ and ∨ buttons to define the ff sound
output area for the higher range.
• By overlapping the L-FADE and H-FADE
curves of each different tone, you can change
the way the tone sounds relative to how hard
or softly the keyboard is played.
5. Repeat steps 2 to 4 for the other tones, as
desired.
TONE DYNAMICS
You can adjust the settings so that a different
sound (tone) is output for each tone depending
on the velocity (how hard the keys are played).
1. Use the PAGE buttons to view the 4/4 display.
• The display looks similar to the following.
2. Use the buttons to the left of the display to
select a tone.
3. Use the ▲ and ▼ buttons to select the column
for the function you wish to adjust.
4. Select the tone waveform.
• Use the GROUP ∧ and ∨ buttons to select the
sound group. Use the TONE WAVEFORM ∧
and ∨ buttons to select the waveform.
5. Use the LEVEL ADJUST ∧ and ∨ buttons to
adjust the volume. Use the FILTER ADJUST
∧ and ∨ buttons to set the sound.
6. Use the VELOCITY ∧ and ∨ buttons to specify
the velocity range.
• When the upper limit of a waveform is set to
127, no more waveforms can be added.
7. Repeat steps 3 to 6 to edit the other
waveforms, as desired.
8. Repeat steps 2 to 7 for the other tones, as
desired.
Sound Edit
Part X Sound Edit
168
QQTG0671
To Next Page
