Technics SX-KN7000 User Manual

3. Use the buttons below the display to assign a
name.
• Press the ABC button to enter alphabetical
characters. While the SHIFT button is
pressed, upper case letters are entered.
• Press the 123 button to enter numbers, etc.
While the SHIFT button is pressed, you can
enter symbols.
• Press the POSITION button to move the cur-
sor.
• You can also use the TEMPO/PROGRAM dial
to select the characters.
• Press the INS button to enter a space at the
cursor position.
• Press the DEL button to erase the character
at the cursor position.
• Press the CLR button to erase the entire
name.
• Press the →← button to center the name.
4. When you have finished typing the name,
press the OK button.
• The display returns to the MEMORY WRITE
display.
5. Use the ∧ and ∨ buttons to select the
MEMORY number in which to store the new
sound (1– 40).
6. Press the OK button.
• The new sound is stored, and “COMPLETED!”
is shown on the display.
• The SOUND EDIT mode is turned off.
• The stored sound memories can be saved on
a disk/an SD card for recall at a later time.
(Refer to pages 130, 147.)
Select a new sound
You can select your original sound just like the
other sounds in the SOUND GROUP.
1. In the SOUND GROUP section, press the
MEMORY button.
• The list of sounds is shown on the display.
2. Select the desired sound from the list on the
display.
MEMORY
Sound Edit
Part X Sound Edit
177
QQTG0671

Technics SX-KN7000 Specifications

General

Brand	Technics
Model	SX-KN7000
Category	Electronic Keyboard
Language	English