TABLE OF
CONTENTS
Technical
specifications/Preparing oven
Page 1
Control
panel
Page 2
Description
of control panel symbols
Page 3
Using
the rotisserie
Page 4
Using
the
grill
Page 4
Electronic
programmer
Page 5-6
Removing
and cleaning the oven door
Page 7
Replacing
the bulb
Page 7
Cleaning
and maintenance
Page 8
Technical
support
Page 8
Instruction
for installation
Page 9
Baking
chart
Page 10
Dear
Customer,
Thank
you for choosing Technika products. We are
sure
that it
will
satisfy all your
requirements and
guarantee
excellent results at all times.
It
is important to carefully
follow
the instructions for correct use
of
the appliance.
The manufacturer
will
not be liable for
damage
to property or
injury
to
persons
caused
by
faulty
or incorrect
installation.
The manufacturer
reserves
the
right
to make alterations to the product at any time
without
notice.
Technical
Specifications
This
appliance complies
with
regulations for the suppression of
radio
interferences.
EMC
Power
supply
voltage
230V
50Hz
Internal
dimensions
Height
Width
Depth
Working
volume
360mm
630mm
395mm
100 litres
Heating
elements
(Kw)
Upper
heating element
Lower
heating element
Circular
heating element
Grill
heating element
Radial
fan
Spit
gearmotor
Oven
light
Cooling
fan
1.05kW
1.55kW
2.50kW
2.50kW
0.025kW
0.004kW
0.015kW
0.07kW
Installation
Qualified
personnel must carry out installation
only.
All
work
must be performed
with
the appliance disconnected. The connection cable must
have
a
minimum
selection
of 1.5mm. The oven must be connected to a
circuit
breaker or fuse of
20amps.
Caution:
the appliance must be earthed in accordance with legal regulations.
Preparing
the oven for use
Clean
the insides of the oven using non-abrasive
soap
and warm water then rinses and
dry.
Switch
the oven on at maximum temperature for approximately 20 minutes in
order to eliminate oil,
grease
and remains of any other products used during
manufacturing
that can
cause
unpleasant smells during cooking.
The appliance is not intended for use by young children or
infirm
persons
without
supervision.
Young
children
must be supervised to
ensure
that they do not play
whit
this appliance.
During
use the appliance
becomes
hot. Care should be taken to
avoid
touching the
external
surfaces
including
the
glass
door or the heating elements inside to oven.
*Note
Never
place
Metal
products on the oven
base
E.G
Pans
or
aluminium
foil.
Always
clean oven
with
non-caustic oven cleaners.
1
To Next Page
Loading...
Need help?
General
