TechniSat DIGIT ISIO S3 - Page 76

76
> By highlighting Accept using the right/le arrow keys and confirming with
the OK buon or by pressing the green function key Accept, the changes are
saved and you move back up to the next menu level.
Alternatively:
> Press the Back key. You are now asked whether the changes made should be
accepted.
> Use the right/le arrow keys to highlight Yes or No and confirm using the
OK buon. According to your selection the changes are now saved or rejected
and you return to the next menu level up.
Alternatively:
> To exit the menu directly, press the Menu or TV/RADIO buon. In this case
seings that need to be saved manually will be reset.
If the green function buon with Accept is not displayed on the boom line of
the screen, the changes are saved automatically on exiting the menu.
By pressing the TV/RADIO buon, you always return to normal TV mode
without saving if you are in a menu.
9.4 Changing a seing
You can create seings using the arrow selection method, the selection list, by
entering numbers and by using the virtual keyboard. The device specifies the
method that can be used to change a highlighted seing. This is evident from the
following displayed symbols:
- Arrow selection method (Item 9.4.1)
Arrows are shown on the le or right edge of the highlight.
- Selection list (Item 9.4.2)
The symbol is shown on the right edge of the highlight.
- Entering numbers (Item 9.4.3)
- Virtual keyboard (Item 9.4.4)
The symbol is shown on the right edge of the highlight.