TechniSat DIGIT ISIO S3 - Page 77

77
DE
EN
9.4.1 Arrow selection
> If is shown on the le and on the right next to the set value, you can
alter this using the le/right arrow buons.
9.4.2 Selection list
> If is shown on the right next to the set value, the value is altered via
the selection list. As an example below, the OSD font size is changed from
"normal" to "small".
> Move the highlight onto the corresponding item and press the OK buon to
open the selection list:
> Highlight the desired seing using the up/down arrow buons.
By pressing the up/down arrow buons it is possible to move the highlight
from line to line, and to move upwards and downwards page by page using
the page up/down buons.
> Confirm by pressing the OK buon. The selection list closes again and the
selected seing is shown in the menu.