TechniSat DIGIT Series User Manual

8
Ending EPG
> By pressing the menu or TV/Radio respectively, you can return to normal operation.
Recording with the timer
Your receiver has a video recorder and station change timer. As to programming these timers, they
only differ according to timer type. You can set the timer manually, as described in this chapter or
with the EPG function.
Programming the timer manually
> Start the main menu with the menu key.
> Select the line “Manage timer” using the up and down arrow keys.
> Confirm with “OK”. The sub menu “Manage timer” appears.
> Choose the timer type you want to set with the up and down arrow keys.
> By pressing the “OK” key, you arrive at the command window for the programming of a new
timer event.
To set this, use the following method:
Source
> Select the column “Source” with the arrow keys.
> Press the “OK” key.
>
Choose the source (TV or radio) in the open selection window with the up and down arrow keys .
> Confirm with “OK”. Now, according to your previous settings, the TV or radio lists are shown.
> Select the program with the arrow keys.
> With the up and down arrow keys, you move up or down one line in the list.
> With the left and right arrow keys, you toggle between pages.
> By pressing the “OK” key, your selection is set in the timer.
Date
> Select the “Date” column with arrow keys.
> Enter the four-number date with the number pad, when the timer event should take place.
Start
> Select the “Start” column with the arrow keys.
> Enter the start time with the number pad.
Stop
> Repeat the steps described in the “Start” section in order to set the ending time (except with
station-change-timer).
Repeat
> Select the “Wdh” column with the arrow keys.
> Press the “OK” key. A selection window with different repeat suggestions appears.
> Choose the desired function with the up and down arrow keys.
> By pressing the “OK” key, the setting is saved.
Saving data in memory
> After you have completed programming, press the yellow function key “Save” in order to save the
data in memory.
Ending timer programming
By pressing the TV/Radio key, you return to normal operation mode.
Further information available on the web at www.technisat.com

TechniSat DIGIT Series Specifications

General

Category	Receiver
DVB Standard	DVB-S2
Common Interface	Yes
HDTV	Yes
USB Port	Yes
Ethernet Port	Yes
HDMI Output	Yes
Scart Output	Yes
Optical Audio Output	Yes
Recording Function	Yes
EPG	Yes
Teletext	Yes
Parental Control	Yes