Need help?Do you have a question about the TechniSat DIGIT Series and is the answer not in the manual?
General| Category | Receiver |
|---|---|
| DVB Standard | DVB-S2 |
| Common Interface | Yes |
| HDTV | Yes |
| USB Port | Yes |
| Ethernet Port | Yes |
| HDMI Output | Yes |
| Scart Output | Yes |
| Optical Audio Output | Yes |
| Recording Function | Yes |
| EPG | Yes |
| Teletext | Yes |
| Parental Control | Yes |
Access options for searching and tuning channels.
Configure device parameters like A/V, system, and service settings.
Manage TV and radio channel lists, and favorites.
Manage access to pay-TV or encrypted channels.
Select the display language for menus and messages.
Connect the antenna cable to the receiver's input.
Connect the receiver to the television via Scart.
Connect the receiver to a VCR via Scart.
Connect the receiver's output to TV antenna input.
Connect the receiver's audio output to a Hi-Fi system.
Connect the receiver to the power supply.
Guide for inserting a smart card into the reader.
Instructions for inserting a Conditional Access Module.
Access on-screen help text via the blue function key.
Guide for the first-time setup wizard.
Powering the device on and off using the remote or unit.
Methods include up/down keys, number pad, and program list.
Switch back to the previously viewed channel using the back key.
Select preferred language or audio tracks for programs.
Adjusting audio loudness using volume +/- keys.
Switching between TV and radio broadcast modes.
Steps to manage favorite channels from main menu.
Moving channels from the whole list to favorites.
Selecting multiple programs simultaneously for operations.
Deleting selected channels from the favorites list.
Deleting selected channels from the main list.
Reordering channels within the favorites list.
Returning to normal operation mode from menus.
Accessing the EPG for program information.
Exiting the Electronic Program Guide interface.
Setting recording timers manually via menu.
Storing programmed timer settings in memory.
Returning to normal mode after setting timers.
To Next Page