47
DE
EN
FR
NL
> The display shows the signal strength using a bar graph. The mark shows the
minimum signal strength.
Stations with a signal strength below the required minimum signal intensity
are not transmiing a strong enough signal. Align the telescopic antenna as
described in Section 4.3.1 if required.
6.2.7 Manual station scan
This menu item is used to check the reception channels and can be used to align the
antenna. Stations can also be added manually.
> Open the MENU > [Scan seings] > [Man. seing] and press the TUNING /
SELECT knob to confirm.
> Select a channel (5A to 13F) by turning and then pressing the TUNING /
SELECT knob. The signal intensity will now be shown on the display. If a
DAB+ station is being received on a channel, the station ensemble name is
displayed. The antenna can now be aligned to the maximum signal intensity.
Stations with a signal strength below the required minimum signal intensity
are not transmiing a strong enough signal. Align the telescopic antenna as
described in Section 4.3.1 if required.
If there are stations on the set frequency or channel that have not yet been
stored in the station list, they will now also be saved.
6.2.8 Volume adjustment (DRC)
The DRC menu item is used to set the compression rate, which compensates for
dynamic fluctuations and the associated volume variations.
> Open the MENU > [Audio seings] > [DRC] and press the TUNING / SELECT
knob to confirm.
DRC high - high compression
DRC low - low compression
DRC o - compression switched o.
> Confirm the seing by pressing the TUNING / SELECT knob.
Signal strength
Minimum signal strength
To Next Page
Loading...
Need help?
General