56
7.3.2 Connecting the mains adapter
Ensure that the operating voltage of the power supply unit matches the
mains voltage before you insert it into the wall socket.
WARNING!
Do not touch the mains plug with wet hands; electric shock hazard!
CAUTION!
Route the mains cable in such a way that nobody can trip over it.
> Connect the supplied mains adapter to the port marked DC-IN (21) on the
back of the DIGITRADIO 586. Then connect the power supply to the mains.
7.3.3 Inserting the baeries into the remote control
> Open the baery compartment on the back of the remote control by sliding it
in the direction of the arrow.
> Insert the baeries (2 x AAA 1.5 V) in accordance with the polarity indicated
in the baery compartment.
> Close the baery compartment lid carefully againand ensure that the lid
retaining tabs engage in the housing.
You will need 2 micro alkaline baeries, 1.5 V, LR03/AAA to operate the
remote control. Make sure the polarity is correct when inserting them.
- Replace baeries that are losing power in good time.
- Leaking baeries can cause damage to the remote control.
- If the device is not to be used for a prolonged period, remove the baeries
from the remote control.
- Important instructions for disposal: Baeries may contain toxic substances
that are hazardous to the environment. Therefore, it is imperative to dispose
of the baeries according to the legal provisions in force. Never dispose of
baeries in normal household waste.
To Next Page
Loading...
Need help?
General