50 51
EN
FR
IT
NL
NW
DK
PL
CZ
SK
14.2.1 WPS connection
> Select WPS set-up if your router has the WPS function. This establishes a direct connection to the router
without having to enter the WLAN password.
If you activate WPS on your router, please observe its instruction manual.
> Start WPS on your router by pressing the corresponding button.
> On the DIGITRADIO select Press button and follow the instructions on the display.
> If your router supports the WPS PIN, on the DIGITRADIO select PIN and take note of the PIN shown on the
display. This PIN must then be entered on the router.
To find out more on the current connection select Seings.
Select Manual seing, if you know your network parameters and would like to configure them manually.
Take note of the instructions on the display.
14.2.2 Deleting network seings no longer required
> Select Delete network profile, to delete connections no longer required.
14.3 Time seings
> Press the MENUbutton and select Main menu System settings > Time settings.
If you are in a submenu, select the Main menu as described in Section 5.1.
> Select Time/date setting to set the time and date manually.
Use the t or u buons to select a value. Change it using the p or q buons.
> Confirm by pressing OK.
> Select Update settings to determine whether the time update should be automatic via DAB, FM or
Internet or whether you would like to enter it manually.
> To do so, select DAB update, FM update, NET update or No update.
> Under the Set format option you can activate 12 or 24 hour format. Confirm your selection with the OK
button.
> Under Time zone, select the current time zone where you are located.
> Under Summertime you determine whether summertime should currently be active.
14.4 Language
> Press the MENU button and select Main menu System settings > Language.
If you are in a submenu, select the main menu as described in Section 5.1.
> Using p or q or SCROLL&SELECT, select the language and confirm the selection by pressing OK.
14.5 Factory seing
If you change the location of the device, e.g. when moving house, it is possible that the saved stations can no
longer be received. In this case you can reset the device to factory settings to delete all the saved stations and
then launch a new scan.
> Press the MENU button and select Main menu System settings > Factory settings.
> Confirm by pressing OK.
> Use t or u to select Yes and confirm the confirmation prompt by pressing OK.
BDA_DIGITRADIO_600_630.indd 50-51 22/06/2018 09:31
To Next Page
Loading...
Need help?
General