This process takes several minutes and is indicated by a flashing radio tower symbol.
If the connection with the DCF radio signal cannot be established, the search is stopped.
Note: If the clock of the weather station cannot receive the DCF radio signal due to errors, too great a distance from
the transmitter or similar reasons, it is possible to set the time manually. If reception of the DCF signal is successful,
the manual settings are overwritten.
Manual settings
The reception of DCF radio signal where the weather station has been positioned may become degraded or
interrupted. If this happens you can set the device manually.
Follow these steps:
1. Press and hold down the MODE button (34) for about 3 seconds. “12Hr” or “24Hr” blinks in the display. Press
the + or – button (35), (36) to choose the desired hour format.
2. Confirm your setting by pressing the MODE button. The temperature unit “°C“ or “°F” flashes in the display.
Press the + or – button to choose the desired temperature unit.
3. Confirm your setting by pressing the MODE button. The barometric pressure’s unit flashes in the display. Press
the + or – button to set the desired unit (hPa/inHg).
4. Confirm your setting by pressing the MODE button. The time zone indicator flashes in the display. Press the +
or – button to set the desired value (-2 to +2). Should You can manually adjust the clock to the time zone of a
country where the clock receives the DCF signal but where the actual time differs from the time received. If, e.g.
the time in a given country is 1 hour ahead of the German time, set the time zone display to 01. The clock is
To Next Page
Loading...
Need help?
General
