Setting the alarm time
1. Press MODE button (34) to switch from time display to ALARM 1 display
2. Press and hold the MODE button for 2 seconds ,the flashing alarm time is shown
3. The hour display of the alarm time is flashing. Use + or – button (35), (36) to select the hour.
4. Press MODE button to confirm.
5. The minute display of the alarm time is flashing. Use + or – button to select the minute.
6. Press MODE button to confirm.
7. Then press MODE button to switch from A1 display to ALARM 2 display
8. The setting sequence for ALARM 2 is the same as for ALARM 1.
Note: Press and hold the + or – button to accelerate the setting of values.
Activating / deactivating the alarm function
1. Briefly press the MODE button (34) briefly once or twice to reach ALARM 1 or ALARM 2 mode.
2. Press the + button (35). The ALARM 1 symbol (3) or ALARM 2 symbol (8) appears in the LCD display. The alarm
has been activated.
3. Press the button + again. The ALARM 1 or ALARM 2 symbol in the LCD display goes out. The alarm has been
deactivated.
Switching off the alarm signal
Press any button except the SNOOZE- /LIGHT button (33) to stop the alarm signal. It is not necessary to reactivate
To Next Page
Loading...
Need help?
General
