Technoalarm TP4-20 - Activation;Deactivation of the Remote Controls

TP4-20 - User Manual Programming
3-17
ACCESS TO THE STANDARD USER PROGRAMMING MENU
In stand-by, i.e. all the programs of the control panel are disarmed and the date and
the time are viewed on the display of the LCD console, enter the standard user menu
by entering the code (e.g. standard user code 1), e.g.:
+ 11111
On the display is viewed ACCESS User 01.
To enter and navigate the standard user programming menu, press the keys:
+ wy
To enter the submenu selected, press:
+ #
Commands available
+ wy to select the submenu
+ # to enter the submenu selected
+ CL-EX to confirm programming and quit
3.2.1 ACTIVATION/DEACTIVATION OF THE REMOTE
CONTROLS
SELECTION OF THE REMOTE CONTROL
+ wy to select the remote control (1 to 2)
+ # to confirm the selection
On the display is viewed the current status:
[ ] Remote control deactivated (in stand-by)
[ # ] Remote control active
Commands available
+ # to activate the remote control selected
+ * to deactivate the remote control selected
+ CL-EX to confirm and quit
3.2.2 CLOCK SETTING
From the standard user programming menu select the submenu clock.
Commands available
+ wy to select the parameter to be modified
+ 0...9 to program the date and the time
+ CL-EX to confirm and quit
3.2.3 PARAMETERIZATION OF THE TELEPHONE SECTION
From the standard user programming menu select the submenu telephone.
The standard user is merely entitled to program the telephone channels. The control
panel supplies 8 independent telephone channels (A...H).
For every channel it is possible to program 2 telephone numbers, one principal that is
always called first and one reserve number that is only called if the line is busy or if
there is no answer. The control panel makes 4 attempts per channel alternating the
principal and the reserve number.
SELECTION OF THE CHANNEL
+ wy to select the telephone channel to be programmed
+ # to confirm the selection
The following parameters can be programmed:
z Principal number (max. 15 digits)
z Reserve number (max. 15 digits)
TELEPHONE NUMBERS
Select the telephone number to be programmed by pressing:
+ wy to select the telephone number to be programmed
+ # to confirm the selection
Commands available
+ wy to delete the last digit
+ 0...9 to program the telephone number
+ #* to program the DTMF symbols # (hash) and * (star) inside the number
+ MEM to program a pause
+ CL-EX to confirm and quit
- ACCESS -
User 01
WARNING
While a console is in use, all the other consoles of the system are disabled and view Waiting.
Menu 10
Telephone
Rem. ctrl 1
Activation [ ]
Fri 30 JAN 04
Work. 11 : 15
Menu 2
Clock
Telephone 3
Channel A
Menu 1
Rem. ctrl
Menu 1
Rem. ctrl
Channel A 1
First number
First number
011555666677777