To Next PageTo Next Page
Need help?Do you have a question about the Technoform NEO-ANGLE and is the answer not in the manual?
Prepare shower alcove with 2"x3" lumber and 1/2" drywall, ensuring it's plumb and square.
Prepare walls with 1/2" drywall, ensuring dryness and cleanliness; cut panels with utility knife.
Place shower base in alcove, level it, and mark a reference line for drywall cutting.
Install the drain, seal if needed, and cut the drain pipe to the correct length.
Drill countersink holes in the tiling flange and secure the base to wall studs with screws.
Place side panels, trace reference lines on wall, apply adhesive, and install panels.
Temporarily place corner caddy, trace reference lines, apply adhesive, and install.
Allow adhesive to cure (min 24 hours) before applying sealant to edges and joints.
Clean with gentle soap; avoid abrasive/corrosive products. Apply car wax for maintenance.
3-year warranty against manufacturing defects; excludes labor, transport, and misuse damages.
General| Brand | Technoform |
|---|---|
| Model | NEO-ANGLE |
| Category | Bathroom Fixtures |
| Language | English |
