28Leg Curl
A
C
B
04194026
Adjusting cable tension
It is possible to take up some of the
slack in the weight stack cable using
the adjuster (C), after loosening the
lock nut (B).
For this purpose, you will need to remove
the back panel of the weight stack
(following the instructions found in the
section
Removing the weight stack
panel).
WARNING
To pull the cable taut after
replacement, it may be helpful,
when tightening the screws (A),
to insert a thickness of approx.
10 mm (1/2") under the first
weight in the weight stack.
Identification of the manufacturer
and the equipment
Description of the equipment
Technical data
Safety labels and devices
Packing
Place of installation
Unpacking
Lifting and handling
the equipment
Adjusting the equipment
Routine maintenance
Replacing
the padded components
Replacing the cable
Adjusting cable tension
Removing
the weight stack panel
Technical Service
Storage
Disposing of the equipment
Using the equipment
Contents
To Next Page
Loading...
