What does COMx error mean in Technogym Fitness Equipment serial ports test?
A "COMx error, press Enter to continue" message during the Serial Ports Test indicates a negative test outcome. The message specifies COM1 for the CSafe COM test, COM2 for low kit communications, or COM3 for the TGS COM test.
Why does Technogym Recline 500SP show 'Test Successful' during the Serial Ports Test?
A "Test Successful, press Enter to continue" message during the Serial Ports Test means that the test was completed successfully, indicating that communications on the selected serial port are functioning correctly. However, a failed "TGS COM test" may occur on machines without a key reader, and a failed "CSafe COM test" may occur if the CSafe port isn't properly connected to the monitor plug.
Manual purpose and target audience.
Steps for planning repair procedures.
Guidelines for performing repairs.
Alphanumeric codes for machine variants and options.
List of machine versions and their characteristics.
Voltage, frequency, and consumption details.
Electrical connection diagrams for models.
Overall machine system block diagram.
Circuit boards constituting the display unit.
Generates low voltages and handles serial communication.
Connecting to a PC for programming.
Kits to convert to Wellness TV display.
Conditions for correct machine installation.
Step-by-step installation procedure.
Initial power-up and operation check.
Accessing diagnostic menus.
Troubleshooting steps for display problems.
Brake board error codes and troubleshooting.
Troubleshooting no or incorrect resistance.
Steps to remove the display unit.
Steps to remove the cardio receiver.
Steps to remove machine guards.
Removing the brake winding assembly.
Removing the hand sensor board.
Adjusting belt tension for optimal operation.
Setting the correct speed sensor position.
Assembling and checking the brake unit.
User menu settings for 700 series machines.
User menu settings for 500 series machines.
Accessing service configuration menus.
TV menu settings for 700iE.
Radio menu settings for 700iE.
Simple cleaning and setup tasks.
Periodic checks of machine operation and wear.
In-depth checks by qualified technicians.
Procedures for updating machine software.
Compatibility between hardware and software versions.
List of tools needed for maintenance.
General| Brand | Technogym |
|---|---|
| Model | Recline 500SP |
| Category | Fitness Equipment |
| Language | English |
To Next Page