18
F
Multi Hip
Contents
Assembling the equipment
To level the platform, use a 17-mm open end wrench to adjust the two rubber threaded feet (F),
on the lower part of the platform. For example, to lower the foot, first back off the nut of the foot
in an anticlockwise direction, and then turn the foot itself until it rests on the floor; then lock down
the nut in a clockwise direction while holding the foot in place.
Warning
Always level the equipment first, and then the platform, NEVER THE OPPOSITE.
In order to move the equipment with the platform assembled, screw the feet (F)
all the way in.
cont.
Identification of the manufacturer
and equipment
Description of the equipment
Technical data
Accessories
Assembling the number holder
Safety labels and devices
Packing
Place of installation
Unpacking
Lifting and handling the
equipment
Adjusting the equipment
Assembling the equipment
Routine maintenance
Replacing the padded
components
Replacing the cable
Adjusting cable tension
Technical Service
Codes for original spare parts
Storage
Disposing of the equipment
Using the equipment
To Next Page
Loading...
